|
|
 |
| Home » Forums » DBManager General |
|
|
| Polish character sets (1307 previews) | |
| Polish character sets | Posted in 04th, 11/2005 05:09 by jbl  |
| How can I enter polish characters into table. Table is defined as latin2 character set. On some computers if I enter polish character, it is properly shown in Table Data, on some other computers - it looks as two question marks.
Do you know, how fix this situation? jbl Jan Błaszczyński / |
|
| Re: Polish character sets | Posted in 04th, 11/2005 11:25 by support |
| Hi,
You didn't mention which database engine and version you are using, not the Windows version, so I will give a generic solution. In any case it is a matter of configuring Windows International Settings. When correctly set the character sets are used as default for any string manipulation. I would strongly recommend to take a look at windows control panel and see if both configurations match. Best Regards, Support / DBTools Software |
|
| Polish character sets (1307 previews) | |
Legends Topic has Replies Topic With no Replies
|
|
| Home » Forums » DBManager General |
|
|
Copyright © 2001-2024 dbTools Software. Best viewed with IE 7.x, Chrome or Firefox 3.x or higher at 1024x768 Register | Contact US | Forums | About US |